
|
Features
· 2 - 12 Bit, 65 MHz A/D (ADC)
Channels
· 2 - 12 Bit, 65 MHz D/A (ADC) Channels
· Hardware Date Packing/Unpacking for Hi-Bandwidth I/O
· 300,000 Gate Xilinx Virtex FPGA |
Applications
· Data Acquisition
· Wireless IF Digitising
· Transient Capture
· Noise Cancellation
· Vibration Monitoring
· Inspection
· Ultrasound
· Magnetic Bearing Control
· Instrumentation
· Scanning Probe Microscopes
· Data Acquisition and Logging
· Digital Radio |
Overview
The CF module is an excellent platform to
develop signal processing in firmware, either for the validation of
new IP logic algorithms using real-world signals, or for the fast
pre-processing of signals in a high-speed data acquisition system.
Much more than a bare-bone development
kit, the CF is a complete, scalable solution combining a Xilinx
XCV300E FPGA with two 12-bit analog I/O (ADC & DAC) channels clocked
up to 65MHz and a bus interface to a DSP.
The CF module allows you to integrate
high-performance signal processing at the logic-level, on a PC
platform, using high-end analog I/O with an accurate DDS or external
clock timebase.
The CF module is ideal for: High Speed Data Acquisition, Wireless
IF Digitising, Transient Capture, Noise Cancellation,
Vibration Monitoring, Inspection, Ultrasound, Magnetic Bearing
Control, Instrumentation, Scanning Probe, Microscopes, Data
Acquisition and Logging, Digital Radio.
The CF module can be used for general purpose
data acquisition tasks on
a PC (fitted to a
ChicoPlus or
cChicoPlus) or remote from a PC (fitted to a
SBC6713e with
EtherNet) by using Real Time
System Editor. |
CF ADC, DAC and Xilinx FPGA Board

Data Sheet
[PDF]
Block Diagram [Flash]
Fits on

ChicoPlus
CompactChicoPlus
M6x/cM6x
SBC6x with USB
SBC6711 with USB
SBC6713e with EtherNet |