Fast Data Acquisition: 80MSPS ADC with Ultra Low Jitter Aperture Control  - TH80


You are on:
HomeDSP Products > Omnibus > TH80
Fast Data Acquisition: 80MSPS ADC with Ultra Low Jitter Aperture Control

Features
· 2 - 14 Bit, 80 MHz A/D (ADC) Channels
· 400MHz input bandwidth
· 32MB Onboard RAM
· Internal Or External Clocking Capabilities

Applications
· Long Burst Capture
· Advanced Radar/Sonarl
· Ultrasound
· Radio Test Equipment
 

Overview

The TH80 is a dual channel high-speed digitizer of very high input bandwidth and up to 80MHz sampling speed. A 32MB on-board DDR RAM allows the capture of long burst at the full 80MHz sampling speed. Control registers are mapped on the 32-bit OMNIBUS interface and control is commanded via software on the host card.

The card can be used for fast signal digitizing between 1 and 80MSPS, acquiring gap-free burst length of up to total on-board RAM capacity. Data can then be transferred at the lower OMNIBUS rates to the base board for post-processing and/or bus-mastering to host PC memory. The A/D conversion clock source is selected between an on-board oscillator (default 80MHz) or an external TTL clock. Error correction is performed in the logic with first order equation where gain and offset coefficients can be written via SW to on-board ROM.

The TH80 can be used for general purpose data acquisition tasks on a PC (fitted to a ChicoPlus or cChicoPlus) or remote from a PC (fitted to a SBC6713e with EtherNet) by using Real Time System Editor.

TH80 ADC & FPGA Board

Data Sheet [PDF]

Block Diagram [Flash]

Fits on

Low Cost PCI Data Acquisition Systems Logging ChicoPlus Low Cost PXI Data Acquisition Systems Logging CompactChicoPlus       Embedded Controller, DSP & Ethernet, Remote Data Acquisition SBC6713e with EtherNet

C6713 DSP, ADC & DAC, Dual FPDP

M6713 PCI

Summary: Fast Data Acquisition: 80MSPS ADC with Ultra Low Jitter Aperture Control  - TH80